DISPOSABLE CAMERA NIXIE TUBE DRIVER

I don’t think very much I’ll check. A disposable camera A potentiometer of Kohms or higher A resistor of 50Kohms or higher Wire cutters A small screwdriver may not be needed, depends on your camera A multimeter A soldering iron Solder Red wire Black wire. This was because 3 was at the top of the electrode stack and looked best. Because of this, they have been harvested for many projects. In the interest of maximizing safety, I chose to put the circuit back into the camera’s shell.

Uploader: Dijora
Date Added: 12 January 2006
File Size: 53.8 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 25095
Price: Free* [*Free Regsitration Required]

Make sure the object you use to discharge with has an insulated handle, and only use one hand to minimize risk of electricity flowing across your chest.

I added an appropriate resistor for my Nixies 47Krealigned the battery holder originally perpendicular to the boardshorted the trigger switch and installed a slide switch on the former cap charge switch.

Hopefully this will lead to a decrease in thier cost. You can’t break even, except on a very cold day.

His high voltage vacuum tube “nixie tube” sounds and looks disposabel lot like a mini rife tube: The gap between cathode and anode in the vacuum tube of the Nixie tube could function as an RF emitter. Exercise caution throughout the following steps to avoid electrical dangers. It looks like your Nixie tube driver is a miniature of my rife device.

Recent Drivers  INTEL 82845G/GL GRAPHICS CONTROLLER DRIVER DOWNLOAD

300 Volts in a roll of film: Ultra-portable Nixie Tube driver

Citing the Original Article. You are commenting using your WordPress. This is brilliant — the HV is the usual problem with Nixie projects, as you either have to camfra power them dangerous or find an isolation transformer not too common nowadays.

Hello- I tested that with a non-rechargable alkaline battery. They come in glass cylinders Hence tubes and have one anode and several cathodes, each of which is shaped into a digit to be displayed. It doesn’t get that cold. Assuming the conversion from 1.

Nixie Tube powered from a disposable camera | Make:

This will enable it to self-discharge in a controlled manner. Sign In or Register to comment.

Because of this, they have been harvested for many projects. I have heard that the only company which still makes nixie tubes a Russian firm has increased production because of the resurgent interest in them. Add a Comment Sign in to comment.

Nixie Tube powered from a disposable camera

Quick Links Categories Recent Discussions. About the best thing you can do with a disposable camera is take it too bits and then throw the bits away as they cannot take decent photos with any of them Regards Adrian. I ran the wires out of the rear viewfinder window, so I had to poke a little piece of plastic out of the window. About the best thing you can do with a disposable camera is take it too bits and then throw the bits away as they cannot take decent photos with any of them.

Recent Drivers  GPS NAVIBE GM720 DRIVER

The black wire will connect to the lead beneath the stripe, and the red wire will connect to the other lead. Notify me of new comments via email. To make this circuit more convenient to use, it is time to add some wires. Then I melted the bottom out of a film can and managed to fit it in if I squashed it a bit Alternatively, you can completely remove the capacitor and never need to worry about stored charge again.

Maybe you could use the Stamp 2 to make specific frequencies to kill microbes under a microscope disoosable using a Nixie tube Never did that again: Notify me of new posts via email. A soldering iron becomes very hot during its use, to the point where it can cause instant second-degree burns.

Once you expose the capacitor, I highly recommend dipsosable it. They have nixies on just about everything in the “Factory”. Email required Address never made public.

This was because 3 was at the top of the electrode stack and looked best.